Free shipping for all orders above 150 

By MTO

Battery Baseplate for Sur Ron Light Bee

2 reviews

18.99 

131.01  left to get free shipping

In stock, ready to ship

Details

Our Light Bee Battery Baseplate improves clearance for aftermarket batteries by offering a lower compartment bottom and a flat surface for perfect battery fitting.

The baseplate is a drop-in replacement for your Sur Ron Light Bee and features integrated mounting holes for you DC converter.

Shipping and returns

We ship worldwide (batteries are limited to Europe). Products indicated as being in stock are shipped in less than 72 hours after you place the order. Our warehouse is located in France, so transport cost and time may vary depending on the delivery country.

Changing one’s mind is human. That’s why you have up to 30 days after the delivery of your order for a return. Just let us know and we will take care of all the details.

Payments

Payments are secured by the highest encryption standard: SSL/TLS 1.3 with a 256 bit AES key.

We offer different payment methods to accommodate your preferences: Credit Cards, PayPal, Wire Transfer & Klarna.

Your order is automatically validated as soon as the payment is confirmed. In case of a return, your refund goes to the payment method used for the order.

Your selection is being restocked, shipping in days. we’ll be shipping it in no time! Your selection is out of stock, we don’t know yet when we’ll have it back 🙈

The Sur Ron Light Bee stock baseplate is very thick and has round edges that often prevent aftermarket batteries to properly sit at the bottom of the battery compartment. Our baseplate does just that: offer a plug and play, flat and thinner bottom plate to maximise space usage in your Sur-Ron’s battery compartment.

We designed our plate as thin as possible to save on vertical space. It is 100% plug and play with mounting holes for the 12V DC converter and features fitting stops for perfect alignment.

Depending on your setup, our baseplate can offer you as much as 2 cm of extra room to fit your battery. On top of that, be aware that batteries that only sit on their corners can be damaged as the load isn’t evenly spread.

We use a next generation polymer from Eastman company that offers extreme robustness while allowing for some flexibility. This will ensure that our plate can adequately fit the underlying metal frame.

Rider’s questions

No questions yet. Be the first to ask a question!

User reviews

3.5 2 reviews

1 - 2 of 2 reviews

caruana.philip

Enduro/Trails

Order:

Comment:

A solid structure for your battery

Good thickness and strength however one of the ordered didn’t have the MTO logo 3d printed correctly😢 and I had to massage and finish of some plastics off to get a correct fit into the metal base underneath it.

I recommend this product

Quentin mto logo

Sorry to hear that! 3D printing isn’t always a perfect process. What happened with the logo? Also, what was the issue with your metal plate? Sometimes the batteries end up curbing them (I have been there…)

bulfr

Enduro/Trails

Order:

Comment:

not to bad but not yet perfect

the plate is good because it gives more room for the battery but on the down side if you have a cable throttle you will not have holes for the screws to fit it, also the holes for the 12 volt converter are a little bit to sensitive be careful not to tighten to much cause it will crack the plate, wish it was done from different material ,more sturdy !

I recommend this product

Quentin mto logo

Thank you for your feedback! We’re taking good note and will try and improve our design, especially for the 12V mounting holes 🙌